GB3RAL on 28 MHz via Meteor Scatter

On Friday the 18th of November, I had the rig turned to 28.2150 MHz, the frequency of the GB3RAL 10 metre beacon in the UK.

I was using Spectrum Lab on the PC with the microphone resting on top of the HF rig....an easy way to monitor a frequency while working away on something else. If there is anything there buried in the noise, it will usually show up on the screen.

I've listened to this back in 2008 and found it hard to get a positive ID. It seemed to be just a carrier without any CW.

This time around, I got 'AL' on cw within about 20 minutes so I knew I was hearing it. There were plenty of pings over the space of an hour and then at about 10:28 UTC, I got this fine 4 minute burst...

Right hand side shows the audio freq in Hz.

The tone was easy to hear at times as it transmitted "GB3RAL IO91IN". It certainly wasn't a huge signal...maybe 419 at best but clear all the same.

I'd imagine it would have been really easy to make a contact on a digital mode like JT65.

It was only afterwards that I noticed that the Leonid meteor shower peaks on the 18th of November so perhaps it was due to one of those.

On a positive note, it's good that the new 10 metre vertical seems to be working well.

GB3RAL and the Leonids Meteor Shower...17th Nov 2008

This is a post that I have been meaning to put up for a while. Now that the peak of the Geminids meteor shower is coming up next weekend (13th of Dec), now seems like a good time to put it up.

During the morning of the 17th of November which was supposed to be the peak of the Leonids meteor shower, I tried listening for the GB3RAL beacon in England on 28.215 MHz.

Equipment.....Kenwood TS690s tuned to 28.215.1 MHz on CW (500 Hz filter fitted)
Antenna........Half wave 10 metre vertical at 5 metres AGL
Distance......490 kms due East from here (IO91in<->IO51tu)

As well as listening by ear to the received signals, I put the microphone from the PC next to the rig and monitored the signal with the Spectrum Lab Audio Analyzer program.

After a while, I got a few audible pings that showed on the waterfall dislay so I could see that there was something there around 500 Hz.



At 09:24, I recorded what was the start of a long 5 to 6 minute burst. As you can see above, it started suddenly and after a few minutes, it began to slowly fade away. Listening by ear, I could just about hear that there was something there yet it showed up quite clearly on the waterfall display.

From what I could hear, there was no cw. It was just a constant carrier.


However when I looked at the display closer, I could see that the signal was about 7 Hz wide before finally becoming a narrower signal. I can see from beacon lists that the GB3RAL beacon uses FSK....i.e. the carrier moves in frequency to generate the CW rather than turning on and off. I asked the beacon keeper G0MJW about this and he informed me that the keyer on the beacon has failed and a replacement is under construction.

What I heard and saw was like the beacon keyer was still working (i.e. FSK) except that the frequency shift was now a lot lower than it should be (i.e. 7 Hz instead of say 300 Hz).

Q. Was it GB3RAL that I heard? Probably likely but to be honest, until I can get a positive ID, I will never be 100% sure. I might have a listen again during the Geminids and see how it goes.

Notes...
(1) The various other lines shown on the above displays are mainly just interference generated by the PC. Even though I can't hear them, they show up quite clearly on the display.